Extreme Networks BlackDiamond 10808 Installation Guide Page 75

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 74
Extreme Networks BlackDiamond 10K-Series Switch Installation Guide 75
8 Initial Switch and Management Access
This chapter describes:
Connecting Equipment to the Console Port on page 75
Logging In for the First Time on page 77
Connecting Equipment to the Console Port
Connection to the console port is used for direct local management. The console port settings are:
Baud rate—9600
Data bits—8
Stop bit—1
•Parity—None
•Flow control—XON/XOFF
The terminal or PC with terminal-emulation software that you connect to the BlackDiamond switch
must be configured with these settings. This procedure is described in the documentation supplied with
the terminal.
Appropriate cables are available from your local supplier, or you can make your own. To ensure the
electromagnetic compatibility of the unit, only shielded serial cables should be used. Table 18 describes
the pinouts for a DB-9 male console connector.
Table 18: Pinouts for the console connector
Function Pin Number Direction
DCD (data carrier detect) 1 In
RXD (receive data) 2 In
TXD (transmit data) 3 Out
DTR (data terminal ready) 4 Out
GND (ground) 5 -
DSR (data set ready) 6 In
RTS (request to send) 7 Out
Page view 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 87 88

Comments to this Manuals

No comments