Extreme Networks BlackDiamond 10808 Installation Guide Page 72

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 71
72 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide
BlackDiamond 10808 Switch Fan Tray
Removing the BlackDiamond 10808 Switch Fan Tray
BlackDiamond 10808 switch fan trays are hot-swappable. You do not need to turn off power to an
BlackDiamond 10808 switch to remove a fan tray.
You need the following tools and equipment to remove a fan tray:
ESD-preventive wrist strap
# 1 Phillips screwdriver
CAUTION
Only trained service personnel should perform service to BlackDiamond 10808 switch fan trays. Before
installing or removing any components, or carrying out any maintenance procedures, see Appendix A.
To remove the fan tray from the BlackDiamond 10808 switch:
1 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground
receptacle that is located on the top-right corner of the switch front panel.
2 Unscrew the two captive screws that secure the fan tray to the chassis by turning them
counterclockwise (to the left).
3 Use the finger grips to pull the fan tray out of the chassis approximately 1 inch (2.54 cm), as shown
in Figure 22; this step disconnects the power and causes the fans to stop rotating.
Figure 23: BlackDiamond 10808 fan tray
EX_012
Fan tray
Page view 71
1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 87 88

Comments to this Manuals

No comments