Extreme Networks BlackDiamond 10808 Installation Guide download pdf (Page 17)

XENPAK Module Installation

Extreme Networks BlackDiamond 10K-Series Switch Installation Guide 17

To install a XENPAK module:

1 Remove the XENPAK module from its antistatic container and remove the dust covers from the

module optical connectors. If your module has a protective pad covering the card-edge connector,

remove it. Store the antistatic container, dust covers, and card-edge connector protective pad in a

clean location from which they can be easily retrieved if you need to uninstall the module.

2 Remove any dust covers from the port on the module into which you are installing the XENPAK.

3 Holding the module by its sides, insert it into the slot on the I/O module.

4 Slide the module as far back into the slot as possible, until you hear it click, indicating that it is

firmly attached.

5 Secure the module to the I/O module faceplate by turning the two captive screws clockwise until

they are hand-tight.

NOTE

To ensure that your module is undamaged upon installation, you can correlate factory test data with

your installation site test data by consulting the average power reference values shown on the XENPAL

module test data sheet (Part No. 121074-00) enclosed with your module.

To remove a XENPAK module:

1 Turn the two captive screws counter-clockwise until they are completely free from the I/O module

faceplate. (The captive screws remain attached to the XENPAK module.)

WARNING!

Remove the SC fiber-optic connector from the XENPAK module prior to removing the XENPAK

module from the I/O module.

2 Gripping both captive screws, gently pull the XENPAK Module out of the slot.

3 Place the dust covers back into the XENPAK Module connectors.

4 Place the XENPAK module immediately into an antistatic container to protect it from ESD damage

and dust.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 87 88

No comments

Extreme Networks BlackDiamond 10808 Installation Guide Page 17