Extreme Networks BlackDiamond 10808 Installation Guide download pdf (Page 59)

Installing I/O Modules

Extreme Networks BlackDiamond 10K-Series Switch Installation Guide 59

8 Ensure that the module is vertical with the module name at the top, the PCB to the right, and that

the ejector/injector levers are extended.

a Slide the module into the appropriate slot of the chassis until it makes contact with the

backplane.

NOTE

Use the metal panel, not the PCB, to guide the I/O module

As the module begins to seat in the chassis, the ejector/injector levers begin to close.

b To close the ejector/injector levers, use both hands simultaneously to push the levers toward the

center of the module.

c To secure the module, tighten the two captive screws using a #1 Phillips screwdriver.

NOTE

Tighten the screws of this module before inserting additional modules. Otherwise, you might unseat

modules that you have not secured.

EX_017

Captive

screws

Open

Injector/

ejector lever

Injector/

ejector leverOpen

Lock

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 87 88

No comments

Extreme Networks BlackDiamond 10808 Installation Guide Page 59