Extreme Networks BlackDiamond 10808 Installation Guide download pdf (Page 53)

Extreme Networks BlackDiamond 10K-Series Switch Installation Guide 53

5 BlackDiamond 10808 I/O Modules

This chapter describes:

• Configuring I/O Modules on page 53

• I/O Module LEDs on page 57

• Installing I/O Modules on page 58

• Verifying the I/O Module Installation on page 60

• Removing I/O Modules on page 61

NOTE

Read the information in this chapter thoroughly before you attempt to install or remove any

BlackDiamond I/O modules.

BlackDiamond I/O modules consist of a printed circuit board mounted on a metal panel that acts as the

insertion vehicle in a BlackDiamond 10808 switch. The module carrier also includes ejector/injector

levers and captive retaining screws at each end of the module front panel.

For more information about BlackDiamond I/O module specifications, see Appendix C, “Module

Technical Specifications.”

Configuring I/O Modules

No configuration information is stored on the I/O modules; all configuration information is stored on

the MSM(s).

When the BlackDiamond 10808 switch is powered on, ExtremeWare generates a default configuration

for any slots that contain I/O modules. The default configuration allows the I/O module ports to

participate in the VLAN named default. The default configuration for the I/O module is not preserved

unless you explicitly save the configuration to nonvolatile RAM (NVRAM).

You can configure parameters of the I/O module after it is installed or you can preconfigure a slot for a

certain type of module and configuration. The preconfigured information is applied to the module after

it is inserted. If you pre-configure a slot for a specific module type, and then insert a different type of

module, the module reverts to its default configuration.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 87 88

No comments

Extreme Networks BlackDiamond 10808 Installation Guide Page 53