Extreme Networks BlackDiamond 10808 Installation Guide download pdf (Page 49)

Installing MSMs

Extreme Networks BlackDiamond 10K-Series Switch Installation Guide 49

9 Ensure that the MSM is vertical as shown in Figure14, with the:

• Module name at the top

• PCB to the right

• Ejector/injector levers extended

Figure 14: MSM prior to insertion in a BlackDiamond 10808 switch

a Slide the MSM into the appropriate lettered slot of the chassis, until it makes contact with the

backplane.

NOTE

Use the metal panel, not the PCB, to guide the MSM.

As the MSM begins to seat in the chassis, the ejector/injector levers begin to close.

b To close the ejector/injector levers, use both hands simultaneously to push the handles toward

the center of the module.

c To secure the module, tighten the two screws with a #1 Phillips screwdriver.

NOTE

Tighten the screws of this module before you insert additional modules. Otherwise, you might unseat

modules that you have not secured.

EX_016

Module status LEDs

Module reset button

Console port

Management port

Compact flash

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 87 88

No comments

Extreme Networks BlackDiamond 10808 Installation Guide Page 49