Extreme Networks BlackDiamond 10808 Installation Guide Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide
BlackDiamond 10808 Switch Overview
Safety Information
Before you begin the process of installing or replacing a mini-GBIC, read the safety information in this
section.
CAUTION
Mini-GBICs can emit invisible laser radiation. Avoid direct eye exposure to beam.
Mini-GBICs are Class 1 laser devices, and they operate at 3.3 V. Use only Extreme Networks-certified
mini-GBIC devices.
If you see an amber blinking mini-GBIC port status LED after you install a mini-GBIC into a
BlackDiamond 10K-series module, this means the mini-GBIC is not certified by Extreme Networks. To
correct this problem, install an Extreme Networks-certified mini-GBIC, available from Extreme
Networks, into the mini-GBIC port.
If you install a mini-GBIC not certified by Extreme Networks into a BlackDiamond 10K-series module
and insert a cable to bring up the link, the port status LED remains “off” and an error specifying the use
of a non-Extreme Networks-certified mini-GBIC is sent to the syslog. To view the syslog and to
determine why the link is down, use the
show log command. To correct this problem, install an
Extreme Networks-certified mini-GBIC, available from Extreme Networks, into the mini-GBIC slot in
the module.
Preparing to Install or Replace a Mini-GBIC
To ensure proper installation, complete the following five tasks before inserting the mini-GBIC:
1 Disable the port that is needed to install or replace the mini-GBIC.
2 Inspect and clean the fiber tips, coupler, and connectors.
3 Prepare and clean an external attenuator, if needed.
4 Do not stretch the fiber.
5 Make sure the bend radius of the fiber is not less than 2 inches (5.08 cm).
Table 5: ZX mini-GBIC specifications
Parameter Minimum Typical Maximum
Transceiver
Optical output power -2 dBm 0 dBm 3 dBm
Center wavelength 1540 nm 1550 nm 1570 nm
Receiver
Optical input power sensitivity -23 dBm
Optical input power maximum -3 dBm
Operating wavelength 1540 nm 1550 nm 1570 nm
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Comments to this Manuals

No comments