Extreme Networks BlackDiamond 10808 Installation Guide download pdf (Page 67)

Installing the Power Supplies

Extreme Networks BlackDiamond 10K-Series Switch Installation Guide 67

Installing the Power Supplies

You need the following tools and equipment to install the BlackDiamond 10808 AC power supply:

• ESD-preventive wrist strap

• AC power supply

To install a power supply:

1 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground

receptacle that is located on the top-left corner of the BlackDiamond chassis front panel.

2 If a blank faceplate is covering the power supply bay, remove it and save it for future use.

3 Ensure that the power supply is right side up and the locking handle is open.

Figure 20: Input and output connectors on back of power supply

4 Gently begin to slide the power supply into the power supply bay.

CAUTION

Do not slam the power supply into the backplane. Use the locking handle to secure the power supply

unit into the chassis.

5 Secure the power supply in a BlackDiamond 10808 switch by pushing down on the locking handle

until it clicks in place.

EX_014

Input

connector

Output

connector

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 87 88

No comments

Extreme Networks BlackDiamond 10808 Installation Guide Page 67