Extreme Networks BlackDiamond 12804 User Manual Page 34
- Page / 160
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Extreme Networks Power Supply Units for BlackDiamond Switches
BlackDiamond 12800 Series Switches Hardware Installation Guide
34
Specifications
The 700/1200 W AC PSU functions from 90 V to 264 V and 47 Hz to 63 Hz AC Input. Each PSU
provides 700 W to the system if the AC input is in the 110 V low-line output power range and 1200 W
to the system if the AC input is in the 220 V high-line output power range.
A greater number of PSUs are needed to support the load if the low-line power range is used to power
the switch. The software determines the maximum available power required for the switch and enables
the modules accordingly.
CAUTION
The 700/1200 W AC PSU does not have a switch for turning the unit on and off. Remove the plug from the
electrical outlet to disconnect power to the 700/1200 W AC PSU. Make sure that this connection is easily
accessible.
Make sure that the 700/1200 W AC PSU circuit is not overloaded. Use proper over-current protection, such as a
circuit-breaker, to prevent over-current conditions.
Extreme Networks 325 W DC Power Supply
Figure 17 shows the Extreme Networks
®
325 W DC UL-listed accessory power supply unit (PSU),
Model 65022. This power supply is compatible with the BlackDiamond 12802 switch. Up to three 325 W
DC PSUs can be installed in the BlackDiamond 12802 switch.
NOTE
A minimum of two Extreme Networks 325 W DC PSUs are required to run a BlackDiamond 12802 switch.
Figure 17: Extreme Networks 325 W DC PSU
NOTE
For centralized DC power connection, this product is intended to be installed in restricted access locations
(dedicated equipment rooms, equipment closets, or the like) in accordance with Articles 110-16, 110-17, and
110-18 of the National Electric Code, ANSI/NFPA 70.
.
325W DC PSU
Torino DC PSU_04
A
- Hardware Installation Guide 1
- Table of Contents 3
- Part 4: Appendixes 6
- Introduction 9
- Conventions 9
- Related Publications 10
- ● Software User Guides 11
- ● Hardware User Guides 11
- Switches 15
- Management Ports 16
- Software Requirements 20
- MSM LEDs 21
- Figure 5: MSM-5 Module 22
- Figure 6: .MSM-5R Module 22
- Figure 7: .MSM-6R Module 22
- I/O Module LEDs 24
- Port LEDs on I/O Modules 24
- GM-20T I/O Module 25
- XM-2X and XM-2XR I/O Modules 26
- XM-2X and XM-2XR LEDs 27
- XM-2HR I/O Module 28
- BlackDiamond Switches 29
- Figure 14: 1200 W DC PSU 30
- Minimum Software Required 31
- Specifications 34
- WARNING! 38
- 4 Site Preparation 41
- Meeting Site Requirements 42
- Wiring Closet Considerations 43
- Temperature 43
- Humidity 44
- Airflow Requirements 44
- Electrostatic Discharge 45
- Securing the Rack 47
- Cabling Standards 48
- Installing Cable 49
- Fiber Optic Cable 50
- Cable Distances 51
- RJ-45 Connector Jackets 52
- Meeting Power Requirements 53
- AC Power Cable Requirements 54
- Applicable Industry Standards 55
- Power cord retaining bracket 58
- 19-inch helper bracket 58
- 5 Unwrap the chassis 59
- Mid-mount 62
- Second mid-mount location 62
- Extreme Networks, Inc 65
- Required Tools and Equipment 66
- Screws (x4) 68
- Grounding point 69
- PSU / fan 69
- Initial Management Access 70
- Logging In for the First Time 71
- Installing the DC Wiring 75
- Squeeze catch 79
- Front Panel LEDs 80
- 325W DC PSU 91
- Torino DC PSU_01A 92
- Torino DC PSU_02A 92
- Torino DC PSU_03A 93
- 325W AC PSU 95
- Torino AC PSU_01 96
- Torino AC PSU_02 97
- Torino AC PSU_07 97
- Torino AC PSU_09 98
- Torino AC PSU_08 98
- Power Supply Cords 100
- Module Slot Assignments 101
- ● ESD-preventive wrist strap 102
- ● #2 Phillips screwdriver 102
- Installing a Backup MSM 105
- Figure 67: Unlocking a Module 107
- Removing a Blank Front Panel 109
- Memory Card 111
- Components 115
- Controllers 116
- Controller 117
- Pre-installation Requirements 118
- Pre-Installation Requirements 119
- Fan tray 120
- Safety Information 125
- Clip lock 127
- Squeeze prongs 127
- BlackDiamond 129
- 12802 switch 129
- 4 Appendixes 131
- A Safety Information 133
- Installing Power Supply Units 134
- Maintenance Safety 135
- General Safety Precautions 135
- Cable Routing for LAN Systems 136
- PoE Devices 136
- Selecting Power Supply Cords 136
- Sicherheitshinweise 140
- Installation von Netzteilen 141
- Wartungssicherheit 142
- Auswahl der Stromkabel 143
- Laserprodukt der Klasse 1 145
- Niederspannungsgeräte 145
- B Technical Specifications 147
- Technical Specifications 148
- BlackDiamond 12802 Switch 149
- Connector Pinouts 153
- Numerics 155
Related products and manuals for Network switches Extreme Networks BlackDiamond 12804
(9 pages)© 2020, manymanuals.com. All rights reserved. | 0.814 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals