Extreme Networks BlackDiamond 12804 User Manual download pdf (Page 109)

BlackDiamond Series Blank Front Panels

BlackDiamond 12800 Series Switches Hardware Installation Guide

109

Figure 69: Blank Front Panels in BlackDiamond Series Chassis

3 Use a #2 Phillips screwdriver to tighten the captive screws at each end of the blank front panel.

NOTE

Tighten the screws of each installed blank front panel before inserting additional modules or blank front panels.

Otherwise, you might unseat modules or blank front panels that you have not secured.

NOTE

Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available when you

need to touch ESD-sensitive components.

Removing a Blank Front Panel

To remove a BlackDiamond blank front panel:

1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground

receptacle on the switch front panel.

On a BlackDiamond 12804 series chassis, the ground receptacle is at the top left corner.

On a BlackDiamond 12802 chassis, the ground receptacle is at the top right corner.

2 Loosen the captive screw at each end of the blank front panel, using a #2 Phillips screwdriver (see

Figure 70).

ASP018

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 159 160

No comments

Extreme Networks BlackDiamond 12804 User Manual Page 109